- Step 1Adjust the governor. To do this, remove the plastic covering behind the seat, find the T-shaped governor, and tie off the silver, thick section of metal to the metal bar behind it. Replace the covering when done.
- Step 2Replace the tires with larger ones with thicker treads. This will allow you better traction at higher speeds, as well as greater revolutions along the ground.
- Step 3Replace the factory gear set with one with a lower ratio.
- Step 4Install a higher amperage, high performance controller.
- Step 5Install a motor with a higher RPM. Check first to make sure that it will fit adequately into the body of your golf cart.
- Step 6Lose excess weight from the golf cart. Find any unnecessary pieces you can safely remove and do so. Just make sure you know what you're removing, and that it isn't neccessary to your golf cart's performance.
Tips & Warnings
- Driving a golf cart with an adjusted governor, especially for extended periods of time, can cause serious damage to the vehicle.
- When adjusting the governor, make sure to do so only after giving the engine time to cool off. Otherwise you risk burning your hand.
- Increasing the speed of your golf cart will most likely result in a loss of low-end torque.
- Driving a golf cart at high speeds can cause damage to the vehicle, and can be dangerous to the driver, passengers and those around the area. Make sure to drive your fast golf cart with extreme caution.

No comments:
Post a Comment